Product Info Sheet
Available In stock
Product Code - 80089
Availability - In stock
Delivery Time - 1-7 Days.
Note: Product usually ships within 24 hours of payment/order.
This assembly supports up to 15 lbs.
Mounting Plate Features
The three position mounting plate can support 1 or 2 arms and can may be rotated and installed vertically or horizontally to create a wider variety of mounting options.
This assembly supports touch screens, terminals or flat panel monitors up to approximately 22” or 15lbs.
Attaches to a shelf, counter or any other flat horizontal surface.
Riser & Riser Cap Features
The 8” arm supporting the screen pan and tilt head can be easily adjusted side to side and locked in any position at the Riser with the three point hand knob.
Integral stop details on the riser and arm can be located at any setting to prevent cable damage when the arm supporting the screen or the printer is rotated around the riser.
The screen pan and tilt heads include integral stop details that limit a full rotation to the right or left to prevent cable damage.
The pan and tilt head or printer can be easily removed from the arm and attached directly to the top of the riser.
The riser cap incorporates a cable tie point to secure the cables so that they will travel safely as the arm is rotated.
A 3”or 6” riser elevates the 8” arm above the mounting surface and permits the screen pan and tilt head or printer tray to travel horizontally and to allow a wide range of positioning options.
Pan and Tilt Head Features
This assembly includes a 75/100mm VESA compatible screen pan and tilt head. If your assembly includes a screen pan and tilt head equipped with an adaptor plate for a proprietary screen type; please refer to the pages that include information specific to that application.
The screen Pan and Tilt Head can be easily adjusted side to side or up and down and locked in any position with the four and five point hand knobs; the positions can also be permanently secured by tightening the lock screws.
Printer Tray Features
The 8” arm supporting the Printer Tray can be easily adjusted side to side and locked in any position at the mounting surface with the five point hand knob; the position can also be permanently secured by tightening the lock screw.
The Flat Printer Tray position can be easily adjusted side to side and locked in any position at the end of the arm with the five point hand knob under the tray; the position can also be permanently secured by turning the lock screw on the bottom bracket of the tray into one of the holes in the end of the arm.
The printer tray includes multiple tie points form adding cable ties to secure the extra cabling and power supply.
The printer tray can be rotated and locked into position without tools.
The positions of the 8” arms adjust without tools to permit the flat printer tray and pan and tilt head to travel horizontally, allowing a range of positioning options.