Product Info Sheet
Available In stock
Product Code - 80021
Availability - In stock
Delivery Time - 1-7 Days.
Note: Product usually ships within 24 hours of payment/order.
This assembly supports up to 15 lbs.
All wall mountable assemblies can be ordered with an optional Stud Bridge Mounting Plate (PN 50486) that supports up to three arms and attaches to wall studs spaced at 16" on center.
Mounting Plate Features
The single position mounting plate may be rotated and installed vertically or horizontally to create a wider variety of mounting options.
This assembly supports touch screens, terminals or flat panel monitors up to approximately 22” or 15lbs.
Attaches to a wall or any other flat vertical surface.
The single position mounting plate can be attached to a pole up to 6” in diameter with an optional strapping kit PQS PN 80801
Adjustable Arm Features
The 8” arm can be easily adjusted side to side and locked in any position at the mounting surface with the five point hand knob. The position can also be permanently secured by tightening a lock screw.
Riser & Riser Cap Features
The 8” arm supporting the pan and tilt head can be easily adjusted side to side and locked in any position at the riser with the three point hand knob.
Integral stop features on the riser and arm can be located at any setting to prevent cable damage when the arm is rotated around the riser.
The pan and tilt head includes integral stop features that limit a full rotation to the right or left to prevent cable damage.
The pan and tilt head can be easily removed from the arm and attached directly to the top of the riser.
The riser cap features a cable tie point to secure the cables so that they will travel safely as the arm is rotated.
A 3”or 6” riser elevates the 8” arm above the mounting surface and permits the pan and tilt head to travel horizontally and to allow a wide range of positioning options.
Please specify either 3" or 6" riser when ordering.
To order this mount with one 6” Riser, use PN 80020 (Click Part Number to go to Product Page)
To order this mount with one 3” Riser, use PN 80021
Pan and Tilt Head Features
This assembly includes a 75/100mm VESA compatible screen pan and tilt head. If your assembly includes a screen pan and tilt head equipped with an adaptor plate for a proprietary screen type; please refer to the pages that include information specific to that application.
The screen Pan and Tilt Head can be easily adjusted side to side or up and down and locked in any position with the four and five point hand knobs; the positions can also be permanently secured by tightening the lock screws.