4X4 Clamp on Mount + Adjustable 8” Arm + Standard VESA Pan Tilt Head

• For complete specifications of this assembly; download the PDF Product Information Sheet; click the "Product Attachments" tab in the middle of this page.

General Features

• This versatile mounting system clamps securely without tools at any point along a vertical 4” square pole with the mounting plate oriented parallel to any of the four sides of a pole.
• This assembly supports any 75 or 100mm VESA compatible screen on a pan and tilt head assembly attached to an adjustable 8” long arm that places the back of the screen approximately 12.5” out from the surface of the vertical 4X4 pole assembly when positioned straight out.
• The mount Includes 4 EA M4 X 10mm L Phillips head screws to attach the screen to the VESA Tilting mount. The side brackets of the pole clamping system are hinged at the mounting plate and close around the 4x4 pole; two four point hand knobs are inserted through the rear flanges and tightened to provide the clamping action. The knobs can be replaced with 5/16” X 1” L hex or security head bolts if desired.
• Self- tapping screws can also be installed into the pole through holes in either of the hinged side brackets to secure the mount permanently.
• Cut out sections on each of the clamping sides allow the mount to be installed over a standard single gang outlet.
• The Standard 75-100mm VESA compatible screen pan and tilt head assembly supports most screens up to 23” W. The Tilt position can be adjusted from +90 degrees to -10 degrees and the pan and tilt head can be rotated up to 270 degrees around the end of the arm depending on the width of the screen.
• The Side to side pan position is adjusted with a 5 point hand knob located under the end of the arm assembly. The screen up and down Tilt position is adjusted with two 4 point hand knobs on either side of the pan and tilt head assembly.
• The side to side position of the arm can be adjusted within 160 degrees with a 5 point hand knob located on the top of the standoff bracket. The knobs work with rubber washers to provide variable clutching resistance.
• Screws located on the top of standoff bracket and on the tilt and pan planes on the head assembly can be tightened to permanently lock the side to side position of the arm mounting plate and screen tilt and pan positions.